Page 3
• module, the Link Gate SIP will convert it in SIP and transfer it to the SIP server (IPBX). For an out going call, the Link Gate SIP process a GSM call when SIP call is receives over IP addresses.
Page 4
In default mode, the Link Gate SIP is set in SIP server mode, to switch to P2P mode, open the unit and changes the dipswitch position N°3 to ON. Dipswitch description: 1 : IP default Configuration. (OFF = Default position)
Page 5
IP SIP Server (SIP Server internal) = 192.168.1.250 / 255.255.0.0 • In your web browser enter IP address of Link gate SIP, defaults setting are 192.168.1.250, user is admin, and password is 1234. Linkcom France 11 rue du Soleil Levant 92140 CLAMART...
Page 8
6.2 Incoming calls trunk route configuration in P2P mode When the Link gate SIP should be set to P2P mode, it is important to set the translation table for incoming phone calls to match phone subscriber extension’s numbers with IP addresses.
Page 9
Password : IPBX extension SIP user name password • Press then « Save changes » to save the parameters. The Link Gate SIP will inform you with a message « Failed Saving » or « Successful Saving » Name or IP adress of external...
In our Example GSM 1 Module prefix is 7 and GSM 2 Module prefix is 8. In SIP SERVER Mode (External), create in the IPBX 2 Trunk SIP routes pointing on IP 1 and IP 2 of the Link Gate SIP.
Page 11
In case GSM1 channel is busy allow to “overflow” to GSM2 Channel automatically. Smart callback: Missed or refused outgoing calls are stored in Link Gate SIP with subscribed number. When called party call back the call is automatically routed to extension which made the call. When connection was successful data are erased from memory.