Table of Contents
Advertisement
b) the decorated middle pane with a frame on the
4 sides must be reassembled so that the
screen-printing is facing outwards. The side of
the pane of glass is correct if you do not feel any
roughness near the screen printing when you
pass your fingers over the surface.
The middle pane of glass must be put back into
the right seats as shown in Fig. 39.
c) the uppermost pane must be reassembled as
shown in Fig. 40.
After the panes of glass have been reassembled
in the oven door, perform the procedure described
in point 8. in reverse to ensure they are locked.
Replacing the oven light
Disconnect the appliance
If the oven bulb needs replacing, it must comply
with the following specifications:
-
Electric power: 40 W,
-
Electric rate: 230 V (50 Hz),
-
Resistant to temperatures of 300°C,
-
Connection type: E14.
These bulbs are available from your local Service
Force Centre.
To replace the faulty bulb (Fig. 41):
1. Ensure the oven is isolated from the electrical
supply.
2. Push in and turn the glass cover anticlockwise.
3. Remove the faulty bulb and replace with the
new one.
4. Refit the glass cover and restore the electrical
supply.
electrolux 37
Fig. 39
Fig. 40
Fig. 41
37
Advertisement
Table of Contents
