Table of Contents
Advertisement
The Demo function remains saved in
the programme in the event of a
power failure.
"Beep" Mode
You can choose to make the electronic control beep
each time that a control is touched.
To enable this function, the oven must be off.
1. Press controls
and " " at the same time for
about 3 seconds. The Electronic Control beeps
once (Fig. 21).
To disable the "Beep" Function:
1. If the oven is on, touch control
off.
2. Press controls
and " " at the same time for
about 3 seconds. The electronic control beeps
once.
Error code
The Oven Electronic Control does a continuous
diagnostic check of the system. If some
parameters are not correct, the control unit will
stop the activated functions and the
corresponding error code will be displayed (letter
"F" followed by digits).
to switch it
electrolux 19
Fig. 21
19
Advertisement
Table of Contents
