Demo Mode; Error Code - Zanussi ZOU 91 K Instruction Booklet

3) Set the temperature by pressing button
" " or " ". The temperature will appear
on the display.
4) Press button
display will show "FHU" (Fig. 18).
5) press button
flash for approximately 10 seconds. Now
it is possible to select the required
temperature by pressing button " " or
" ".
4) When the required temperature is reached,
an acoustic alarm will sound for a short
time, and the temperature display will
revert to the set temperature.
This function can be used with any cooking
function or temperature.

Error code

The electronic programmer does a continu-
ous diagnostic check of the system. If some
parameters are not correct, the control unit
will stop the activated functions and it will
show on the display the corresponding error
code (letter "E" followed by number digits -
see Fig. 20).
For further details, refer to chapter "What
happens if something goes wrong" on page
97.
14
B
. The temperature
and the symbol "°" will

Demo mode

This mode is intended to be used at the shops
to demonstrate the oven functionality without
any power consumption except the oven
lamp. To activate this function the appliance
should be in stand-by mode.
—
Press button
mately 2 seconds (Fig. 19). An acoustic
alarm will sound for a short time.
—
Press button
will appear on the display .
All oven functions can be selected.
The thermometer symbol will not flash any-
id
more and " " indication will be replaced by
number digits.
Follow the above described procedure
to disable the demo mode.
" "
B and for approxi-
id
and the " " indication
B
B
B
Fig. 18
Fig. 19
Fig. 20