Setting Guidelines; Generic Communication Function For Double Point Indication Dpgapc; Identification - ABB 650 series Applications Manual

1MRK 511 423-UEN A
8.5.3
8.6
8.6.1
Bay control REC650 2.2 IEC
Application manual
diagram symbols (or use it in the configuration through the outputs POS1 and
POS2) as well as, a command function (controlled by the PSTO input), giving
switching commands through the CMDPOS12 and CMDPOS21 outputs.
The output POSITION is an integer output, showing the actual position as an
integer number 0 – 3, where 0 = MidPos, 1 = Open, 2 = Closed and 3 = Error.
An example where VSGAPC is configured to switch Autorecloser on–off from a
button symbol on the local HMI is shown in figure86. The I and O buttons on the
local HMI are normally used for on–off operations of the circuit breaker.
VSGAPC
PSTO
INTONE
IPOS1
IPOS2
NAM_POS1
OFF
NAM_POS2
ON
IEC07000112 V3 EN-US
Figure 86: Control of Autorecloser from local HMI through Selector mini switch
VSGAPC is also provided with IEC 61850 communication so it can be controlled
from SA system as well.

Setting guidelines

Selector mini switch (VSGAPC) function can generate pulsed or steady commands
(by setting the Mode parameter). When pulsed commands are generated, the length
of the pulse can be set using the tPulse parameter. Also, being accessible on the
single line diagram (SLD), this function block has two control modes (settable
through CtlModel): Dir Norm and SBO Enh.
Generic communication function for Double Point
indication DPGAPC

Identification

Function description
Generic communication function for
Double Point indication
CMDPOS12 ON
CMDPOS21 OFF
IEC 61850
identification
DPGAPC
Section 8
Control
INVERTER
OUT
INPUT
SMBRREC
SETON
IEC07000112-3-en.vsd
GUID-E16EA78F-6DF9-4B37-A92D-5C09827E2297 v3
IEC 60617 ANSI/IEEE C37.2
identification device number
- -
SEMOD158807-4 v4
SEMOD55384-1 v4
163