AP110 and AP1014i Monitoring and Management
Commands
You can use the CLI to monitor and manage VPN and the mesh network.
VPN
To display the VPN server status and VPN IP pool, use the following command:
controller# show vpn-server
To display a list of VPN-connected APs, use the following command:
controller# show vpn-ap
To display the VPN status of an AP, use the following command:
controller# show ap-connectivity ap-id
Substitute the AP ID value for ap-id.
To display VPN status, use the following commands:
controller# conn ap ap-id
Substitute the AP ID value for ap-id.
ap id> ip vpn show
VPN
Status
VPN Server Host Name :
Controller Public IP : 172.18.41.16
Controller Tunnel IP : 192.168.2.1
Controller VPN Port
Data Encryption
VPN Connect Mode
ap 3>
If any changes are made in certificates used for VPN, use the following command:
controller(config)# reload-vpn
Use the following commands to add or remove an AP from a VPN group:
controller(config)# ap ap-id
controller(config-ap)# connectivity l3-preferred
controller(config-ap-connectivity)# vpn
controller(config-ap-connectivity)# no vpn
To display certificate and CA information and the connectivity mode of an AP:
controller# show ap-certificate ap-id
32
: Enabled
: 1194
: Enabled
: Enabled
For use by Meru Networks authorized partners and customers.