Table of Contents
Advertisement
IPv6 bridging is supported for wired stations, just as it is for wireless stations.
Wired station assignment is also managed by the controller. The controller
communication includes connect, assign, and delete messages between the AP and
controller for a wired station assignment and removal from station database.
The age out timer for wired stations is 1800 seconds (30 minutes). In other words, a
wired station that is idle for 1800 seconds is automatically removed from the station
table.
You can enable the default wired port profile using the
Web UI
To enable the default wired port profile:
1.
Select Configuration > Wired > Port.
2.
Select the check box for the default profile, and click Settings.
The Port Table page appears, as shown in
Multicast settings are applicable only for the APs that are part of this profile.
3.
In the Enable/Disable list, select Enable.
4.
Click OK.
CLI
To enable the default wired port profile, use the following commands. For the last command,
substitute the AP ID value for ap-id.
controller(config)# port-profile default
controller(config-port-profile)# enable
controller(config-port-profile)# port-ap ap-id
For use by Meru Networks authorized partners and customers.
Web UI
or CLI.
Figure
3. The VLAN, Dataplane Mode, and
13
Advertisement
Table of Contents
