To Resume; Deactivation - Dodge charger 2018 User Manual

Metric Speed (km/h)
• Pushing the SET (-) button once will result in
a 1 km/h decrease in set speed. Each subse-
quent tap of the button results in a decrease
of 1 km/h.
• If the button is continually pushed, the set
speed will continue to decrease in 10 km/h
decrements until the button is released. The
decrease in set speed is reflected in the in-
strument cluster display.
NOTE:
• When you override and push the SET (+)
button or SET (-) buttons, the new set speed
will be the current speed of the vehicle.
• When you use the SET (-) button to deceler-
ate, if the engine's braking power does not
slow the vehicle sufficiently to reach the set
speed, the brake system will automatically
slow the vehicle.
• The ACC system applies the brake down to a
full stop when following a target vehicle. If an
ACC host vehicle follows a target vehicle to a
standstill, the host vehicle will release the
vehicle brakes two seconds after coming to a
full stop.
124
• The ACC system maintains set speed when
driving up hill and down hill. However, a slight
speed change on moderate hills is normal. In
addition, downshifting may occur while
climbing uphill or descending downhill. This
is normal operation and necessary to maintain
set speed. When driving up hill and down hill,
the ACC system will cancel if the braking
temperature exceeds normal
(overheated).

To Resume

If there is a set speed in memory push the RES
(resume) button and then remove your foot from
the accelerator pedal. The instrument cluster
display will display the last set speed.
NOTE:
ACC cannot be resumed if there is a stationary
vehicle in-front of your vehicle in close
proximity.
WARNING!
The Resume function should only be used if
traffic and road conditions permit. Resuming
a set speed that is too high or too low for
WARNING!
prevailing traffic and road conditions could
cause the vehicle to accelerate or decelerate
too sharply for safe operation. Failure to fol-
low these warnings can result in a collision
and death or serious personal injury.

Deactivation

range
Push and release the Adaptive Cruise Control
(ACC) on/off button a second time to turn the
system off.
"Adaptive Cruise Control (ACC) Off" will appear
in the instrument cluster display to indicate the
ACC is off.
WARNING!
Leaving the ACC system on when not in use
is dangerous. You could accidentally set the
system or cause it to go faster than you want.
You could lose control and have an accident.
Always leave the system OFF when you are
not using it.