Dodge charger 2018 User Manual page 25

3. Once the profile has been recalled, push and
release the set (S) button on the memory
switch, then push and release memory but-
ton (1) or memory button (2) accordingly.
"Memory Profile Set" (1 or 2) will display in
the instrument cluster display.
4. Push and release the lock button on the key
fob within 10 seconds.
NOTE:
Your key fobs can be unlinked from your
memory settings by pushing the set (S) button,
and within 10 seconds push the unlock button
on the key fob.
Memory Position Recall
NOTE:
The vehicle must be in PARK to recall memory
positions. If a recall is attempted when the
vehicle is not in PARK, a message will display in
the instrument cluster display.
To recall the memory settings for driver 1, push
memory button (1) on the driver's door or the
unlock button on the key fob linked to memory
position 1.
NOTE:
If the vehicle is equipped with Passive Entry, the
memory settings will be recalled with a Passive
Entry Unlock into the driver's door using the key
fob linked to position 1.
To recall the memory setting for driver 2, push
memory button (2) on the driver's door or the
unlock button on the key fob linked to memory
position 2.
NOTE:
If the vehicle is equipped with Passive Entry, the
memory settings will be recalled with a Passive
Entry Unlock into the driver's door using the key
fob linked to position 2.
A recall can be cancelled by pushing any of the
memory buttons (S, 1, or 2) on the driver's door
during a recall. When a recall is cancelled, the
driver's seat or power tilt and telescopic steering
column (if equipped) stop moving. A delay of
one second will occur before another recall can
be selected.
Easy Entry/Exit Seat
This feature provides automatic driver seat po-
sitioning to enhance driver mobility when enter-
ing and exiting the vehicle.
The distance the driver seat moves depends on
where you have the driver seat positioned when
you cycle the vehicle's ignition to the OFF posi-
tion.
• When you cycle the vehicle's ignition to the
OFF position, the driver seat will move about
2.4 inches (60 mm) rearward if the driver seat
position is greater than or equal to 2.7 inches
(67.7 mm) forward of the rear stop. The seat
will return to its previously set position when
you cycle the vehicle's ignition to the ACC or
RUN position.
• The Easy Entry/Easy Exit feature is disabled
when the driver seat position is less than
0.9 of an inch (22.7 mm) forward of the rear
stop. At this position, there is no benefit to the
driver by moving the seat for Easy Exit or Easy
Entry.
Each stored memory setting will have an asso-
ciated Easy Entry and Easy Exit position.
23