To Deactivate; To Resume Speed; To Vary The Speed Setting - Dodge Charger SRT Hellcat 392 2016 Owner's Manual

172 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

To Deactivate

A soft tap on the brake pedal, pushing the CANC button
or normal brake pressure while slowing the vehicle will
deactivate the Electronic Speed Control without erasing
the set speed from memory.
Pushing the on/off button or turning the ignition to the
OFF position erases the set speed from memory.

To Resume Speed

To resume a previously set speed, push the RES (+)
button and release. Resume can be used at any speed
above 20 mph (32 km/h).

To Vary The Speed Setting

To Increase Speed
When the Electronic Speed Control is set, you can in-
crease speed by pushing the SET + button.
The driver's preferred units can be selected through the
instrument panel settings if equipped. Refer to "Under-
standing Your Instrument Panel" for more information.
The speed increment shown is dependant on the chosen
speed unit of U.S. (mph) or Metric (km/h):
U.S. Speed (mph)
• Pushing the SET + button once will result in a 1 mph
increase in set speed. Each subsequent tap of the
button results in an increase of 1 mph.
• If the button is continually pushed, the set speed will
continue to increase until the button is released, then
the new set speed will be established.
Metric Speed (km/h)
• Pushing the SET + button once will result in a 1 km/h
increase in set speed. Each subsequent tap of the
button results in an increase of 1 km/h.