Dodge charger 2018 User Manual page 16

To Lock The Doors And Trunk
Push and release the lock button on the key fob
to lock all doors.
The turn signal lights will flash and the horn will
chirp to acknowledge the signal if programmed.
Refer to "Uconnect Settings" in "Multimedia"
for further programmable information.
NOTE:
To lock the doors with passive entry, Refer to
"Keyless Enter-N-Go — Passive Entry" located
in "Doors" in "Getting To Know Your Vehicle" in
the Owner's Manual for further information.
If one or more doors are open, or the trunk is
open, the doors will lock. The doors will unlock
automatically if the key is left inside the passen-
ger compartment, otherwise the doors will stay
locked.
14
Request For Additional Remote Controls
NOTE:
Only key fobs that are programmed to the ve-
hicle electronics can be used to start and oper-
ate the vehicle. Once a key fob is programmed
to a vehicle, it cannot be programmed to any
other vehicle.
WARNING!
• Always remove the key fobs from the ve-
hicle and lock all doors when leaving the
vehicle unattended.
• For vehicles equipped with Keyless Enter-
N-Go — Ignition, always remember to
place the ignition in the OFF mode.
Duplication of key fobs may be performed at an
authorized dealer. This procedure consists of
programming a blank key fob to the vehicle
electronics. A blank key fob is one that has
never been programmed.
NOTE:
When having the Sentry Key Immobilizer Sys-
tem serviced, bring all vehicle keys with you to
an authorized dealer.
General Information
The following regulatory statement applies to all
radio frequency (RF) devices equipped in this
vehicle:
This device complies with Part 15 of the FCC
Rules and with Industry Canada license-exempt
RSS standard(s). Operation is subject to the
following two conditions:
1. This device may not cause harmful interfer-
ence, and
2. This device must accept any interference
received, including interference that may
cause undesired operation.
NOTE:
Changes or modifications not expressly ap-
proved by the party responsible for compliance
could void the user's authority to operate the
equipment.