Dodge charger 2018 User Manual page 27

WARNING!
• Persons who are unable to feel pain to the
skin because of advanced age, chronic
illness, diabetes, spinal cord injury, medi-
cation, alcohol use, exhaustion or other
physical condition must exercise care
when using the seat heater. It may cause
burns even at low temperatures, especially
if used for long periods of time.
• Do not place anything on the seat or seat-
back that insulates against heat, such as a
blanket or cushion. This may cause the
seat heater to overheat. Sitting in a seat
that has been overheated could cause se-
rious burns due to the increased surface
temperature of the seat.
Rear Heated Seats
On some models, the two outboard seats are
equipped with heated seats. The heated seat
switches for these seats are located on the rear
of the center console. There are two heated seat
switches that allow the rear passengers to
operate the seats independently.
You can choose from HI, LO, or off heat settings.
The indicator lights in each switch indicate the
level of heat in use. Two indicator lights will
illuminate for HI, one for LO, and none for off.
• Push the heated seat button
select HI-level heating.
• Push the heated seat button
time to select LO-level heating.
• Push the heated seat button
to turn the heating elements off.
NOTE:
• Once a heat setting is selected, heat will be
felt within two to five minutes.
• The engine must be running for the heated
seats to operate.
If the HI-level setting is selected, the system will
automatically switch to LO-level after approxi-
mately 60 minutes of continuous operation. At
that time, the number of illuminated LEDs
changes from two to one, indicating the change.
The LO-level setting will turn off automatically
after approximately 45 minutes.
Front Ventilated Seats
If your vehicle is equipped with ventilated seats,
the seat cushion and seat back will have fans
that draw the air from the passenger compart-
once to
ment and move air through fine perforations in
the seat cover to help keep the driver and front
passenger cooler in higher ambient tempera-
a second
tures. The fans operate at two speeds, HI and
LO.
a third time
The front ventilated seats control buttons are
located within the Uconnect system. You can
gain access to the control buttons through the
climate screen or the controls screen.
• Press the ventilated seat button
choose HI.
• Press the ventilated seat button
time to choose LO.
• Press the ventilated seat button
time to turn the ventilated seat off.
NOTE:
The engine must be running for the ventilated
seats to operate.
once to
a second
a third
25