Display Board Board & Control Board - EdgeStar BBR900BL Service Manual

3. DISASSEMBLY
2. Take out the LED light connector. Remove the
screws from LED light.
(figure 2 8 )
3. The LED light is like below. (figure 29)
3-4 DISPLAY BOARD & CONTROL BOARD
(Models：CBR901SG, CWR301SZ, BWR300BL,
BBR900BL, CBR1501SG, CWR531SZ, CWR1661SZ,
CWR1211SZ)
1. Loosen four screws. (figure 30 )
2. Pull out the electrical box.
3.
Unplug all cable connectors. (figure 31)
4. Press the plastic nail supporting the control board with
forefinger and thumb.
Figure 30
Screw
Figure 31
5. The control board is like below. (figure 32)
Figure 28
6. Disassemble the display board. (figure 33)
Figure 29
7. The display board is like below. (figure 34)
(Models：CBR1501SLD, CBR1501SSOD)
1. Loosen four screws. (figure 35)
2. Pull out the electrical box.
- 15 -
Figure 32
Figure 33
Figure 34
Figure 35
Screw