Wires Shelves; Lamp - EdgeStar BBR900BL Service Manual

3. DISASSEMBLY

GLASS SHELVES
(Models：CBR901SG，CBR1501SG, CBR1501SLD,
CBR1501SSOD)

Open the door completely.

If necessary, make sure you remove all the
contents sitting on the shelf.

Remove both of the plastic notches with a
screwdriver.
 Continue to pull the shelf forward until it is
completely removed from the inner
compartment. (Figure 6)



WIRES SHELVES

TYP A : (Models：CWR181SZ，CWR301SZ，
BWR300BL，BBR900BL，CWR531SZ)
 Open the door completely.
 If necessary, make sure you remove all the
contents sitting on the shelf.
 Pull the shelf forward until the notch aligns with
the plastic post on each side of the shelf track.
 Lift the shelf until both notches pass through the
posts.
 Continue to pull the shelf forward until it is
completely removed from the inner compartment.
(Figure 7)
TYP B : (Models：CWR70SZ)

Open the door completely.

Make sure the shelf is pushed back completely
(towards the rear wall).

If necessary, make sure you remove all the
contents sitting on the shelf.
 Identify the protective stoppers located on the
right and left sides of the back of each shelf.


Figure 6

3-3 LAMP

1.
2.
Figure 7
- 12 -
Lift either the left or right side of the shelf
creating a 45° angle from its original position.
Make sure not to lift either side of the shelf too
hard as it may come in contact with the inner
wall mount.
Pull the shelf forward until it is completely
removed from the inner compartment. Set
aside safely. (Figure 8)
(Models：CBR901SG, CWR301SZ, BWR300BL,
BBR900BL, CBR1501SG, CWR531SZ, CBR1501SLD,
CBR1501SSOD, CWR1661SZ, CWR1211SZ)
Loosen four screws. (figure 9)
Loosen the display PCB board fixer and take out the PCB
board. (figure 10)
Figure 8
screws
Figure 9
Figure 10