Operation; Installation Check List Before Operation; Using The Temperature Control Panel - EdgeStar CBR901SG Owner's Manual

OPERATION
Installation Check List before Operation
1. Have all packing materials and tape been removed from the interior and
exterior of the beverage cooler?
2. Have the installation instructions been followed, including connecting the
machine to electricity? And has proper grounding been installed for the beverage
cooler?
3. Has the machine been leveled?
4. is the beverage cooler in a site where the ambient temperature is between 50 °
F and 95 ° F all year round?
5. is there a clearance of at least 2" to 3" at the rear for proper air circulation?
Using the Temperature Control Panel
i RunUght J Temp. B _ttons
Light Button ] [ Power Button J
Celsius and Fahrenheit
Lights
I SetDispiay 1 Current Temperature I
Use the up and down buttons to adjust the temperature. The temperature
displayed can be in Fahrenheit or Celsius. This beverage cooler has a
temperature range from 38°F to 50°F.
Note: Whether your
beverage cooler can reach
the actual set temperature
depends on the ambient
environmental conditions.
This beverage cooler has two displays, a Set Display that shows the set
temperature, and a Current Temperature Display that shows the current
temperature. Note: It is normal to see the set temperature and current
temperature displays being a few degrees off from each other.
Press the 'V' button on the control panel to lower the temperature by 1
degree increments.
Caution: If you powered off
the unit, please wait at least
5 minutes before powering it
back on.
Allow at least 24 hours before storing your beverages and to allow the
temperature to acclimate.
Press the ,& button on the control panel to increase the temperature by 1
degree increments.
Press the button to turn the inner light on or off.
Press and hold the power button for approximately 3 seconds to turn the
unit's power on or off. The Run Light will illuminate when the unit is
working.
The Celsius or Fahrenheit light will be lit depending on what scale
temperature is being displayed. To switch between C and F, press and
hold the V and ,A. buttons at the same time for approximately 5 seconds
until the temperature scale changes.
EdgeStar Built-in Beverage Cooler 8