Disassembly; Door; Wooden Shelves - EdgeStar BBR900BL Service Manual

3. DISASSEMBLY

3-1 DOOR

(Models：CBR901SG, CWR301SZ ，BWR300BL，
BBR900BL，CWR361FD，CBR1501SG，CWR531SZ，
CBR1501SLD，CBR1501SSOD，CWR5631FD，
CWB2886FD )
Loosen 2 bolts fixing the lower door axis to the
lower hinge to remove the door. (Figure 1)
(Models：CWR1661SZ，CWR1211SZ)
Loosen 2 bolts fixing the lower door axis to the
lower hinge to remove the door. (Figure 2)
(Models：CWR181SZ，BR7001SS，BR7001SSOD，
BR7001BL，CWR70SZ)
Open the door and using a Phillips screwdriver,
remove the two bottom screws from the lower
hinge. Be careful to hold the glass door with hands
from dropping after removing the screws.. (Figure 3)
Lower Door Axis
Lower Hinge
BOLT Figure 1
Figure2
Lower Hinge
Figure3

3-2 WOODEN SHELVES

TYP A : ( Models： CWR361FD )
 Open the door completely.
 If necessary, make sure you remove all the
contents sitting on the shelf..
 Pull the shelf forward until the notch aligns with
the plastic post on each side of the shelf track.
 Lift the shelf until both notches pass through the
posts.
 Continue to pull the shelf forward until it is
completely removed from the inner compartment.
(Figure 4)
TYP B : ( Models： CWR5631FD, CWB2886FD )

Open the door completely.

Make sure the shelf is pushed back completely
(towards the rear wall).

If necessary, make sure you remove all the
contents sitting on the shelf.

Identify the protective stoppers located on the
right and left sides of the back of each wood
wine shelf.

Lift either the left or right side of the shelf
creating a 45° angle from its

original position. Make sure not to lift either
side of the shelf too hard as it may come in
contact with the inner wall mount

Pull the shelf forward until it is completely
removed from the inner compartment. Set
aside safely. (Figure 5)
- 11 -
Figure 4
Figure 5