Table of Contents
Advertisement
Assembly Instructions / Power2 800-M
1
Introduction
1
Introduction
1.1
Purpose of the assembly instructions
The assembly instructions explain how the low- and high-pressure stage of ABB Turbo Sys-
tems is fitted to the engine correctly and without any health and safety risks. This element of
the documentation is supplied with the product, as is required for partly completed machinery
in accordance with machinery directive 2006/42EC.
The assembly instructions are a complement to and expansion of existing national regulations
for occupational safety, accident prevention and environmental protection.
1.2
Definition of target group
The assembly instructions are intended for engineers and mechanics responsible for fitting the
low- and high-pressure stage on the engine. Basic mechanical training is a prerequisite.
All persons who are involved in the transportation and installation of the low and high-pressure
stage have read and understood the assembly instructions.
1.3
Symbols, definitions
Symbols
The following symbols are used in this document:
Indicates an action step.
1. Indicates a numbered action step.
Indicates a list.
[➙ ] Refers to a page number
Terms used
The following terms are used in this document:
Two-stage turbocharging (Power2)
Low-pressure stage (Power2 LP)
High-pressure stage (Power2 HP)
Low-pressure and high-pressure stage
The trademarks of outside companies are used in this document. These are marked with the
® symbol.
© Copyright 2016 ABB. All rights reserved.
HZTL455311P0010
Page 2 / 21
Revision -
March 2016
Advertisement
Table of Contents
