Table of Contents
Advertisement
Assembly Instructions / Power2 800-M
2
Safety
2.2
Lifting of loads
Suspended loads
Loads that are not attached according to regulations can cause injury to per-
sonnel or fatal accidents.
WARNING
Loads must always be fastened to properly functional lifting gear with a
sufficient load limit.
Pay attention to the correct attachment of loads on the crane hook.
People must not stand beneath suspended loads.
Wear safety gloves against mechanical risks.
Wear safety helmet.
Figure 1: Attachment of loads on the crane hook
Figure 2: Attachment angle
If there are two or more suspension points, the attachment angle of 45° must not be exceed-
ed. This prevents excessive loading due to diagonal pull.
Use a suitable edge guard if there are sharp edges.
The assembly devices must be completely screwed in and must not unscrew during use.
Use assembly devices only for the described applications.
© Copyright 2016 ABB. All rights reserved.
HZTL455311P0010
Page 6 / 21
Revision -
March 2016
Advertisement
Table of Contents
