Assembly Procedure - ABB Power2 800-M Original Assembly Instructions

Assembly Instructions / Power2 800-M
5 Installing the high-pressure stage
5.2

Assembly procedure

Air suction branch with bellows installed
If the high-pressure stage is transported with the air suction branch and bel-
lows installed, the bellows may be damaged.
CAUTION
Transport and put down air suction branch together with bellows separate-

ly.
Figure 9: Installing the high-pressure stage
Attach one lifting gear to the two suspension points of the bearing casing and one lifting

gear to the support.
Check that the orifices specified for the high-pressure stage have been installed in both oil

supply pipes.
Check that the gaskets have been correctly fitted at the oil inlet and the oil outlet in the

bracket.
Check that the sleeves of the bearing casing fixing screws have been correctly fitted.

Align the high-pressure stage on the engine.

Tighten fixing elements at foot and support (see Table 11).

Connect the cable connector to the speed sensor.

Install air suction branch together with bellows.

Secure all gas, air, water and oil pipes.

© Copyright 2016 ABB. All rights reserved. HZTL455311P0010
Page 17 / 21
Revision - March 2016