Table of Contents
Advertisement
The driver aligns the bus according to the lines on the road or by one of the other alignment
options (see section Alignment of the bus on page 11).
The driver indicates the readiness to start charging by applying the handbrake.
4.3. Charging procedure starts
Pantograph comes down automatically. Time between applying the handbrake (initiate cycle)
and start charging is between 15-30 seconds, depending on integration at the bus side.
PE and safety check (continuous) is performed between the bus and the charger.
➢ When safety check is positive: start of power flow.
➢ When safety check is negative: Pantograph goes up automatically and bus driver
receives a notification on the dashboard (e.g. when the positioning of the bus is not
correct).
Status during charging can be checked by reading out the dashboard display in the bus or by
looking at the charge status indicator light (beacon) on the charge pole (see section
Description of user interface on page 10).
Document: v0.4 / Document No.: 6AGA000008-0607-EN | Date: 22-05-2019
Page 14 of 25
Advertisement
Table of Contents
