Keypad Control Menu (M3) - Vacon nxp/c User Manual

vacon • 76
Keypad
Parameters
G1

Keypad
Min Frequency
13.95 Hz
9.3.3

Keypad control menu (M3)

Keypad Controls Menu
In the
change the direction of the motor. Enter the submenu level with the
Code Parameter
P3.1 Control place
R3.2 Keypad reference
P3.3 Direction (on keypad)
R3.4 Stop button
9.3.3.1 Selection of control place
There are three different places (sources) which the frequency converter can be controlled from.
For each control place, a different symbol will appear on the alphanumeric display:
Change the control place by entering the edit mode with the
be browsed through with the
button . See the diagram on the next page. See also 9.3.3 above.
9
Input signals
READY
Basic parameters
G8
READY
Min Frequency
enter
Figure 46. Parameter value change procedure
, you can choose the control place, edit the frequency reference and
Table 25. Keypad control parameters, M3
Min Max
1 3
Par.
Par. 2.1.1
2.1.2
0 1
0 1
Control place
I/O terminals
Keypad (panel)
Fieldbus
Browser buttons
Keypad
G1  G8
READY
Keypad
P18
P1

READY
Keypad
14.45 Hz
Unit Default Cust
1
Hz
0
1
symbol
I/O term
Keypad
Bus/Comm
Menu button right
. Select the desired control place with the
Tel. +358 (0) 201 2121 • Fax +358 (0)201 212 205
CONTROL KEYPAD
READY
Keypad
Min Frequency
13.95 Hz
Menu button right
.
ID Note
1 = I/O terminal
125 2 = Keypad
3 = Fieldbus
0 = Forward
123
1 = Reverse
0 = Limited function of Stop button
114
1 = Stop button always enabled
. The options can then
11529_uk
Enter