Configuration; Main Menu - Planet GSW-1602SF User Manual

The GSW-1602SF/GSW-2404SF/GSW-2416SF Web Smart Gigabit Ethernet Switch provide Web interface for Switch
smart function configuration and make the Switch operate more effectively - They can be configured through the Web
Browser. A network administrator can manage and monitor the GSW-1602SF /GSW-2404SF/GSW-2416SF from the local
LAN. This section indicates how to configure the Switch to enable its smart function.
Notice:
The following section will base on the console screens of GSW-2404SF, for GSW-1602SF and GSW-2416SF the display
will be the same to GSW-2404SF.

4.1 Main Menu

After a successful login, the main screen appears, the main screen displays the Switch status. The screen in Figure 4-1
appears.
As listed at the left of the main screen, the configurable smart functions are shown as below:
◆ System – Check the hardware, software version and System MAC address. Setting the IP address and SNMP
management for the switch. Explain in section 4.2
◆ Port Configuration – Setup per port Speed/Duplex mode, Flow Control and jumbo frame. Explain in section 4.3
◆ Port Mirroring – dedicated port monitoring for incoming packets. Explain in section 4.4
◆ Storm Control – various type of storm control value assign. Explain in section 4.5
◆ VLANs – Configure VLAN Member / Port Configuration. Explain in section 4.6
◆ Rapid Spanning Tree – Configure Rapid spanning tree topography for any arrangement of bridges . Explain in
section 4.7
◆ Link Aggregation – Port Trunk / LACP. Explain in section 4.8
◆ IGMP Snooping – Enables or disables IGMP Snooping on the device to filter the multicast stream. Explain in
section 4.9
◆ Quality of Service – Mapping the packet level to classify the packets priority. Explain in section 4.10
◆ 802.1X Management – Specify ports with network access control. Explain in section 4.11
◆ Filter Configuration – per port traffic filter based on IP address. Explain in section 4.12

4. CONFIGURATION

Figure 4-1 Web Main screen
-12-