Cyclades AlterPath ACS Command Reference Manual page 306

Profile Configuration
Parameter
conf.dhcp_client
conf.eth_ip_alias
conf.eth_mask_alias
conf.rlogin
conf.facility
conf.group
conf.eth_ip
Description
It defines the dhcp client operation mode.
Valid values:
0 - DHCP disabled
1 - DHCP active
2 - DHCP active and the unit saves the last IP
assigned by the DHCP server in flash.
Secondary IP address for the Ethernet interface (needed
for clustering feature).
Note: This parameter is inactive by default. To activate,
uncomment the parameter and set the desired value.
Mask for the secondary IP address above.
Note: This parameter is inactive by default. To activate,
uncomment the parameter and set the desired value.
It defines the location of rlogin utility
Note: This is a parameter specific to TS profile.
The local facility sent to syslog-ng from PortSlave.
Used to group users to simplify the configuration of the
parameter all.users later on. This parameter can be used
to define more than one group.
Note: This parameter is inactive by default. To activate,
uncomment the parameter and set the desired value.
Configured in Chapter 4. This is the IP address of the
Ethernet interface. This parameter, along with the next
two, is used by the cy_ras program to OVERWRITE
the file /etc/network/ifcfg_eth0 as soon as the command
"runconf" is executed. The file /etc/network/ifcfg_eth0
should not be edited by the user unless the cy_ras
configuration is not going to be used.
Note: This parameter is inactive by default. To activate,
uncomment the parameter and set the desired value.
Table 8.1: /etc/portslave/pslave.conf common parameters
Factory Configuration
2
0
0
/usr/local/bin/rlogin-radius
7
0
0 (IP address received
from DHCP Server)
290