Cli Method - Ntp - Cyclades AlterPath ACS Command Reference Manual

Administration
To save the changes, run the command:
# saveconf

CLI Method - NTP

To configure an NTP server using the CLI follow the steps below:
1. Open the CLI interface by issuing the command:
# CLI
cli> config administration ntp xxx.xxx.xxx.xxx
Where xxx.xxx.xxx.xxx is the IP address of the NTP server.
Note:
NOTE:
issuing the command:
cli> config administration date/time date <mm/dd/yyyy>
cli> config runconfig
cli> config savetoflash
To exit the CLI mode and return to ACS 's shell, type the following command:
cli> quit
a. Set the IP address of the NTP server.
To deactivate the NTP service you just need to configure date by
a. Activate the configuration.
a. Save the configuration.
a. Exiting the CLI mode.
200