Siemens SINUMERIK 840Di Operator's Manual page 7

0
03.02
Preface
Organization of
documentation
Target group
Hotline
Internet address
Objectives
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Operator's Guide CAD Reader (CAD) – 03.02 Edition
SINUMERIK documentation is organized on 2 separate levels:
• General Documentation
• User documentation
This Manual is intended for machine-tool users. This publication
provides detailed information that the user needs to operate this
application for the SINUMERIK 840D/840Di/810D controls.
If you have any queries, please contact the Hotline given below:
A&D Technical Support Tel.: ++49-180-5050-222
If you have any questions about the documentation (suggestions,
corrections), please send a fax to the following fax address or email:
A&D Technical Support Tel.: ++49-9131-98-2176
Fax form: See Suggestions/Corrections Sheet at the back of the
document.
http://www.ad.siemens.de/sinumerik
This Operator's Guide describes the CAD Reader PC application and
how to use it. The CAD Reader enables you to convert drawings
constructed with a CAD system for further processing on a
SINUMERIK control. The format of the imported file is DXF (Drawing
eXchange Format) from which contours or drill points are filtered out.
Note
The CAD Reader can be used for systems with the following software
versions:
Controls SINUMERIK 840D/840Di/810D
Target systems HMI Advanced or HMI Embedded SW 5.1 and higher
ShopMill and ManualTurn
ShopTurn
Please note the supplementary conditions regarding the number of
cycles.
Structure of manual
Fax: ++49-180-5050-223
Email: motioncontrol.docu@erlf.siemens.de
0
Preface
All versions
SW 5.3 and higher
SW 6.2 and higher
0-7