Address Space - Siemens SIMATIC ET 200SP Manual

Parameters/address space

4.3 Address space

4.3 Address space
The module can be configured differently in STEP 7; see following table. Depending on the
configuration, additional/different addresses are assigned in the process image of the inputs.
Configuration options of RQ 4x24VUC/2A CO ST
You can configure the module with STEP 7 (TIA Portal) or with a GSD file. If you configure
the module using a GSD file, the configurations are available under various short
designations/module names; see the table below. The following configurations are possible:
Table 4- 2 Configuration options with GSD file
Configuration
1 x 4-channel without value
status
1 x 4-channel with value
status
Evaluating the value status
An additional two bytes are allocated in the input address space if you enable the value
status for the digital module. Bits 0 to 3 in these bytes are assigned to a channel. They
provide information about the validity of the digital value.
Bit = 1: No fault is present on the channel.
Bit = 0: Channel is disabled or there is a fault/error on the module.
If a fault/error occurs on a channel with this module, the value status for all channels is 0.
Address space
The following figure shows the assignment of the address space for the RQ 4x24VUC/2A
CO ST with value status (Quality Information (QI)). The addresses for the value status are
only available if the value status is enabled.
Figure 4-1
18
Short designation/module
name in the GSD file
RQ 4x24VUC/2A CO ST
V0.0
RQ 4x24VUC/2A CO ST V0.
0, QI
Address space of the digital output module RQ 4x24VUC/2A CO ST
Configuration software, e.g. with STEP 7 (TIA Portal)
Integrated in hard-
ware catalog
STEP 7
V14, SP1 or higher
with HSP 0222
V14, SP1 or higher
with HSP 0222
Digital output module RQ 4x24VUC/2A CO ST (6ES7132-6GD51-0BA0)
GSD file GSD file
PROFINET IO PROFIBUS DP
X
X
Manual, 09/2017, A5E32855952-AB
X
---