Alg Settings - Planet XRT-104D User Manual

Destination Port Range
Protocol
WAN Port
Add a Rule
Remove a Rule
Click <Save> at the bottom of the screen to save the above configurations and press "Apply and
Reboot" to apply the configuration and reboot the XRT-D router. You can now configure other
advance sections or start using the router (with the advance settings in place).

3.4.6 ALG Settings

You can select applications that need "Application Layer Gateway" to support.
Only packets with this assigned destination port range
will statically bind to the assigned WAN port.
Only packets with this assigned protocol will statically
bind to the assigned WAN port.
The WAN port that the packets matching this rule are
statically bound to.
Fill in the "Source IP Range", "Destination IP Range",
"Source
Port Range",
"Protocol" or "WAN Port" of the setting to be added and
then click "Add". Then this rule of Protocol and Port
Binding will be added into the "Protocol and Port Binding
Table" below. If you find any typo before adding it and
want to retype again, just click "Reset" and the fields will
be cleared.
If you want to remove some rule of Protocol and Port
Binding from the "Protocol and Port Binding Table",
select the rules you want to remove in the table and then
click "Delete Selected". If you want remove all rules from
the table, just click "Delete All" button. Click "Reset" will
clear your current selections.
43
"Destination Port Range",