Table of Contents
Advertisement
Confirmed Password
Click <Save> at the bottom of the screen to save the above configurations and press "Apply and
Reboot" to apply the configuration and reboot the XRT-D router. You can now configure other
advance sections or start using the router (with the advance settings in place).
3.1.3 Remote Management
The remote management function allows you to designate a host in the Internet the ability to
configure XRT-D from a remote site. Enter the designated host IP Address in the Host IP Address
field.
Parameters
Host Address
Port
Enter your new password again for verification purposes.
Note: If you forget your password, you'll have to reset the router
to the factory default (password is "1234") with the reset button
(see router's back panel)
Description
This is the IP address of the host in the Internet that will have
management/configuration access to XRT-D from a remote site. This
means if you are at home and your home IP address has been
designated the Remote Management host IP address for this router
(located in your company office), then you are able to configure this
router from your home. If the Host Address is left 0.0.0.0 this means
anyone can access the router's web-based configuration from a remote
location, providing they know the password.
Click the Enabled box to enable the Remote Management function.
Note: When you want to access the web-based management from a
remote site, you must enter the router's WAN IP address (e.g. 10.0.0.1)
into
your
web-browser
http://10.0.0.1:8080 (see below). You'll also need to know the password
set in the Password Setting screen in order to access the router's web-
based management.
The port number of remote management web interface.
followed
by
25
port
number
8080,
e.g.
Advertisement
Table of Contents
