Antenna Setup; Satellite List - Triax S-HD11 User Manual

4.1.1

Antenna setup

In the Installation menu press CH+/
page (See Fejl! Henvisningskilde ikke fundet. Fejl! Henvisningskilde ikke fundet.).
Fejl! Henvisningskilde ikke fundet. Fejl! Henvisningskilde ikke fundet.
There are these setting items:
Satellite: Satellite: Satellite: Satellite: Select a satellite from the existing satellite list.
•
LNB Type: Set the working frequency band for LNB (three options: Ku Band, C Band User, Unicable and JESS). LNB Type: LNB Type: LNB Type:
•
LNB Frequency: LNB Frequency: Set the local oscillation frequency of LNB.
LNB Frequency: LNB Frequency:
•
Transponder: Transponder: Select a transponder from the existing transponder list.
Transponder: Transponder:
•
22KHz: 22KHz: Turn on or off the 22KHz switch (On, Off). 22KHz: 22KHz:
•
LNB Power: LNB Power: LNB Power: LNB Power: Set whether or not there is a STB to supply power to LNB.
•
Tone Burst Mode: Tone Burst Mode: Select tone burst mode (three potions: Tone Burst A, Tone Burst B, NONE).
Tone Burst Mode: Tone Burst Mode:
•
DiSEqC DiSEqC DiSEqC (Digital Satellite Equipment Control) Mode: DiSEqC
•
select one LNB to input.
In the Antenna Setup page, you can press CH+/
the editing state press CH+/ CH+/- - - - keys to select an option and then press OK
CH+/ CH+/
4.1.2

Satellite list

The Satellite List (see figure left) shows all the satellites, the system has stored. Users can press color function keys on the remote controller to
edit the list, for example to add a satellite (by pressing the red function key), to delete a satellite (by pressing the yellow function key), to search
the selected satellite (by pressing the blue function key), etc.
Also you can press the green function key to edit the detailed information of the selected satellite: Satellite Name, Position and Longitude. See
the figure to the right.
EN
CH+/- - - - keys to highlight the Antenna Setup sub item and then press OK
CH+/ CH+/
Mode: Select input signal. When more than one LNB is used, DiSEqC can be used to Mode: Mode:
CH+/- - - - keys to highlight a setting item and then press OK
CH+/ CH+/
OK key to enter corresponding editing state. In
OK OK
OK key to exit editing.
OK OK
20
User manual
OK or V+ V+ keys to enter the Antenna Setup
OK OK V+ V+