Planet VRT-401 User Manual page 46

VRT-401 User Manual
Data - Special Applications Screen
Use this to Enable or Disable this Special Application as required.
Checkbox
Enter a descriptive name to identify this Special Application.
Name
Incoming
Ports
Outgoing
Ports
Using a Special Application
Configure the Special Applications screen as required.
On your PC, use the application normally. Remember that only one (1) PC can use
each Special application at any time. Also, when 1 PC is finished using a particular
Special Application, there may need to be a "Time-out" before another PC can use
the same Special Application. The "Time-out" period may be up to 3 minutes.
Figure 27: Special Applications Screen
Type - Select the protocol (TCP or UDP) used when you receive
data from the special application or service. (Note: Some applica-
tions use different protocols for outgoing and incoming data).
Start - Enter the beginning of the range of port numbers used by
the application server, for data you receive. If the application uses
a single port number, enter it in both the "Start" and "Finish"
fields.
Finish - Enter the end of the range of port numbers used by the
application server, for data you receive.
Type - Select the protocol (TCP or UDP) used when you send
data to the remote system or service.
Start - Enter the beginning of the range of port numbers used by
the application server, for data you send to it. If the application
uses a single port number, enter it in both the "Start" and "Finish"
fields.
Finish - Enter the end of the range of port numbers used by the
application server, for data you send to it. If the application uses a
single port number, enter it in both the "Start" and "Finish" fields.
42