Nokia Customer Care
you are using:
•
"AMPS Tx
•
"Cell Tx
•
"PCS
Setup" on page
AMPS Tx Setup
Use the following procedures to prepare for AMPS Tx troubleshooting using Phoenix.
Note the 6236i variant does not support AMPS.
1. Connect the RF test connector to a spectrum analyzer.
2. Connect the mobile terminal to the PC via a test jig. (The bottom connector is a
USB port.)
3. Connect a power supply to the mobile terminal.
4. Open the Troubleshooting menu, and click Phone Control.
The Phone Control dialog box appears.
5. Click the LOCAL button in the Phone State tab to put the mobile terminal into
Local Mode.
6. Open the Troubleshooting menu, point to AMPS, and click AMPS Control.
Issue 1 04/2005
Setup" on page
11
Setup" on page
14
16
Figure 7: Phone Control dialog box
©2005 Nokia Corporation
6235/6235i/6236i (RM-60)
RF Description and Troubleshooting
Company Confidential
Page 11