Setup For Tx Troubleshooting - Nokia 2608 Service Manual

Setup for TX Troubleshooting

U se the following steps to configure FTM mode for RF troubleshooting.
1. Connect RF connector to a spectrum
2. Put PWB on the module jig, connect data service cable between PC and Module Jig and connect a power
supply
3. Launch Nokia CDMA L3 P
4. The RF T oolkit box a
5. Set "Sta rt RF connection"
6. Set "Set Mode" to "FTM"
7. Set "Set Band " to "Cellular band 800"
8. Set "Set Channel " to Channel "384"
9. Set "Set PA Range" to "1" --> "R0=1"
10. Set "Waveform" to "ON"
11. Set "Set TX on/off" to "ON"
12. Set "Set TX AGC" to "80"
13. Get HDET value by setting "Set ADC Channel" to "4" and "Get ADC".
Page 4-18
ST Fx.x Service Software and run RF Toolkit function
ppears
Figure 7 RF Toolkit setup for TX troubleshooting
Company Confidential
Copyright © 2008 Nokia. All rights reserved.
RM-376
RF Troubleshooting
Issue1