Ftm Setup For Tx Troubleshooting - Nokia 1265 Description And Troubleshooting

Nokia Customer Care

FTM Setup for Tx Troubleshooting

Put PWB on the module jig. Use the following steps to configure FTM for RF
troubleshooting.
1. Connect RF test connector to a spectrum.
2. Set to "FTM mode" in Module Jig.
3. Connect the mobile terminal to a PC via the Module Jig, and connect a
power supply.
4. Open CCS RF Tools software.
5. The FTM dialog box appears.
6. "Select COM port" to appropriate one
7. Set "Connect Phone".
8. Set "Set FTM".
9. Set "Set Band" to "CDMA800".
10. Set "Set Channel "to Channel "384".
11. Set "Set Pa Range R1" to "on"
12. Set "Set TX waveform" to "CDMA"
13. Set "Set TX on/off" to "on".
14. Set "Set TX AGC" to "90".
15. Select "ADC Channel" to Channel "4".
16. Click "Get ADC" bottom to Power detector ADC value.
Issue 1 04/2007
Figure 5: FTM dialog box
© 2007 Nokia Corporation
RF Description and Troubleshooting
Company Confidential
1265 (RH-103)
Page 7