Notifier AFP-300 Manual page 2


Distributed voice options (XP transponders).

Firefighter telephone option.

30- to 120-watt high-efficiency amplifier.

Backup tone generator and amplifier option.

Dual channel option.
• Telephone control module type ID.
• Optional UDACT, 396-channel digital alarm communi-
cator transmitter with AC fail delay.
• 80-character displays (up to 32) for remote annunciation.
• ACS annunciators (EIA-485), including LDM custom.
• Two-wire detector interface provides compatibility with
many manufacturers' detectors for retrofit applications.
• Integral printer interface (80-column and 40-column
printers).
• Integral 80-character LCD display, backlit (2 lines x 40
characters).
• Field-programmable on panel or on PC, with program
check, compare, simulate.
• Full QWERTY keypad behind flip-down door.
• Autoprogramming and Walk Test.
• Identifies two devices set to the same address.
• History file with 800-event capacity in nonvolatile
memory, plus separate 200-event alarm-only file.
Page 2 of 10 — DN-5262 • 10/31/05
• Programmable waterflow or supervisory selection per
point.
• Alarm Verification selection per point, with tally.
• Verification Trouble counter. Trouble indication after a
detector verifies 20 times.
• Programmable Positive Alarm Sequence (PAS) Presignal
per NFPA 72.
• Silence inhibit and Auto Silence timer options.
• Programmable non-alarm points for lower priority func-
tions.
• Remote ACK / Silence / Reset / Drill via addressable
modules.
• Maintenance Reports may be sorted via PC by compen-
sation value (dirty detector), peak alarm value, or address.
• Automatic time control functions, with holiday exceptions.
• Dual rate charger for up to 90 hours of standby power.
• Rapid poll algorithm for manual stations. Responds to
alarm/activation in less than three seconds.
• SLC loop maximum length 10,000 feet (3,048 m) @ 12
AWG (3.31 mm²).
• Surface Mount Technology (SMT) electronics.
• High-speed RISC 16-bit microprocessor.
• Extensive built-in transient protection.