Table of Contents
Advertisement
Vectron
10.8 Specific requirements from FCC chapter 15
10.8.1 15.203 Antenna requirement
An intentional radiator shall be designed to ensure that no antenna other than furnished by the responsi-
ble party shall be used with the device. The use of a permanently attached antenna or of an antenna that
uses a unique coupling to the intentional radiator shall be considered sufficient to comply with the provi-
sions of this Section.
The antennas of the product are permanently attached.
10.8.2 15.204 External radio frequency power amplifiers and antenna modifications
a) Except as otherwise described in paragraph (b) of this section, no person shall use, manufacture etc.
any external radio frequency power amplifier or amplifier kit intended for use with a Part 15 intentional
radiator.
The product offers no means for connection of an external RF power amplifier.
b) A transmission system consisting of an intentional radiator, an external radio frequency power ampli-
fier, and an antenna, may be authorized, marketed and used under this part.
Does not apply. The product has no external RF amplifier. The product has no external antenna.
c) Only the antenna with which an intentional radiator is authorized may be used with the intentional
radiator.
The antenna is permanently attached inside the housing of the product
10.8.3 15.205 Restricted bands of operation
The product operates in the frequency band 2400 – 2483.5 MHz. See test house report for spurious
emissions.
10.8.4 15.207 Conducted limit
See test house report
10.8.5 15.209 Radiated emission limits
See test house report
© Höft & Wessel AG
Subject to amendment, errors excepted
User manual
HW90195UserMan.doc
1.0
02.02.2001
Lin
page 66/70
Advertisement
Table of Contents
