Printer - Vectron HW 90196 User Manual

Vectron
Standard settings
Resets radio module to standard settings.
Sent commands Display
SPBD115200
SPTM PT
SPPR OFF
SPCTR OFF
SPCCN 1
SPINI 0 Setting of standard
settings successful!
Firmware:
Displays of radio module firmware. The user test menu contains DECT in a submenu with the function
„firmware" and a notice about the version number and the manufacturer date of the radio module firm-
ware.
Download:
Download of the radio modules with new firmware, the files root.pp and root.bin have to be generated on
the Flash-disk beforehand.
This function does not refer to the mobile printer HW 90195.

5.5.3 Printer

- HW 90196 -
DECT menu
->Printer menu
END
->DECT serial no
Offline Sub. SK
Oflline Sub SMK
Air Subscription
Defaults
Firmware
END
To configure the radio module in the printer the terminal and the printer have to be aligned with their infra-
red interfaces on the bottom sides of the devices towards each other. The printer must be in IR mode
(see also chapt. 6.6). Stray light influences, e.g. by fluorescent lamps, should be avoided, if possible.
© Höft & Wessel AG
Subject to amendment, errors excepted
User manual
Possible error messages
Setting of standard settings
failed!
Enter the code "30141590" from the basic state of the operating system.
Select „Printer menu" with arrrow keys.
Enter (↵) for confirmation.
Menu levels DECT-menu Printer
Select with arrow keys and enter (↵) for confirmation.
The DECT-menu for the printer is, concerning its functions, equal to the
one for the HW 90196. The DECT-menu for the terminal additionally con-
tains the menu level „download".
HW90195UserMan.doc
Remarks
1.0 02.02.2001 Lin
page 28/70