Table of Contents
Advertisement
Vectron
4.2 Charging condition of accu block
The loading capacity of accu block should always be used to full extend. Keep HW 90196 in operation
until the message „attention! Recharge batteries!!!" is indicated in the display. After this the device can
still be used for a while, however only essential inputs should be entered and the accu block be re-
charged afterwards.
If the accumulator voltage drops below a permitted value, the device switches off automatically. After
switch on display indicates „emergency cutout! check accu!!!".
Accu block can be recharged in accu charging unit HW 16196 (see sec. Fehler! Verweisquelle konnte
nicht gefunden werden.) or in communication station HW 50196.
4.3 Replacing the accu block in HW 90196
Following steps are required to change the accu block in HW 90196:
fig. 4: Replacin accu block of HW 90196
General:
It is not recommended to pull out accu block while HW 90196 is still switched on. Operating
states that lead to a system crash after restart of the device might appear.
IMPORTANT!
Swich off device before taking out accu block!
Taking out the accu block during an accounting operation with the customers smart
card inserted might destroy the smart card!
© Höft & Wessel AG
Subject to amendment, errors excepted
User manual
1. Switch off HW 90196 with key
vice on rear side.
2. Push locking button of accu casing towards top and
remove lid of accu casing.
3. Remove accu block.
4. Insert new accu block (reverse battery protection-no
vice versa insertion possible),
5. Replace accu casing lid and close.
HW90195UserMan.doc
1.0
02.02.2001
Lin
and turn de-
page 18/70
Advertisement
Table of Contents
