Radio Module Configuration Menu (Dect-Menu); Terminal; Functions - Vectron HW 90196 User Manual

Vectron
385
formatting
completed -> C
After confirmation with the C-key in display 385 the FLASH-disk has been formatted succesfully.

5.5 Radio module configuration menu (DECT-menu)

5.5.1 Terminal

- HW 90196 -
->DECT menu
Printer menu
END
->DECT serial no.
Offline Sub. SK
Oflline Sub SMK
Air Subscription
Defaults
Firmware
Download
END

5.5.2 Functions

All avaible functions, their expressions, display indications and commands that will be transmitted to the
radio module within the configuration mode, will be explained in the following. These functions are also
selected by the enter- and arrow-keys. Due to the changed format of the commands all functions are
classified as new and old firmware. The radio module firmware version will be determinded before trans-
mission of a command.
These functions prove to be advantageous as they enable a configuration of the radiio module without
having loaded an application program beforehand and thus an application program can later be dupli-
cated onto the Flash-disk via radio connection. Even in the case of an unintentional delete of the applica-
tion program at the customers place, the terminal does not need to be sent to the service department.
© Höft & Wessel AG
Subject to amendment, errors excepted
User manual
C
Enter the code "30141590" from the basic state of the operating system.
Select „DECT-menu" with arrow keys.
Enter (↵) for confirmation.
Menu levels of DECT -menu
Select with arrow keys and enter (↵) for confirmation.
HW90195UserMan.doc
300 system menu
1.0 02.02.2001 Lin
page 26/70