Wieland wienet v3 User Manual page 93

Mobile WAN
configuration The mobile connection can be configured the same way as in the previous
situations (router connects itself after inserting the SIM card into SIM1 slot and attaching the antenna to
the ANT connector), configuration is accessible in the
chapter 4.3.1), where mobile connection has to be enabled.
OpenVPN configuration is accessible in the
two possible tunnels and enable it checking the Create 1st
protocol and port (according to the data about opposite side of the tunnel or Open VPN server). Fill in the
public IP address of the opposite side of the tunnel including the remote subnet and mask (not neces-
sary). Important items are
ends has to be filled in. In this situation the
thentication Mode
item and insert the secret (key) into the field. Confirm the configuration clicking the
Apply
button. For detailed configuration see chapter 4.10.
Status Network
In the section,
with the IP addresses of the tunnel's ends set. Successful connection can be verified in the
where Initialization Sequence Completed should be written out. Networks are now intercon-
nected – it can be verified by the ping program also (ping between tunnel's endpoints IP addresses from
one of the routers, console is accessible via SSH).
Wieland Electric GmbH | BA001039 (Rev. A) | 08/2016
Configuration
Local Remote Interface IP Address
and
pre-shared secret
Secure networks interconnection –
item, you can verify the activated network interface tun0 for the tunnel
Configuration in Typ. Situations
Configuration section, the
section in the OpenVPN
OpenVPN
tunnel. It's necessary to fill in the
where the interfaces of the tunnel's
was know, so choose this option in the
OpenVPN
configuration
Mobile WAN item (see
item. Choose one of
Au-
System Log
94