Table of Contents
Advertisement
5.6
WLAN Configuration
Attention!
This item is available only if the router is equipped with a WiFi module.
AT TENT I ON
The form for configuration of WiFi network and DHCP server functioning on this network can be invoked by
pressing the
WLAN
item in the main menu of the router web interface.
the top of this form is used to activate WIFi LAN interface. It is also possible to set the following properties:
Item
Description
Operating Mode
WiFi operating mode:
• access point (AP) – router becomes an access point to which other devices in
• station (STA) – router becomes a client station, it means that receives data pack-
DHCP Client
Activates/deactivates DHCP client
IP Address
Fixed set IP address of WiFi network interface
Subnet Mask
Subnet mask of WiFi network interface
Bridged
Activates bridge mode
• no – Bridged mode is not allowed (it's default value). WLAN network is not con-
• yes – Bridged mode is allowed. WLAN network is connected with one or more
Default Gateway IP address of default gateway. When entering IP address of default gateway, all packets
for which the record was not found in the routing table are sent to this address.
DNS Server
Address to which all DNS queries are forwarded
Enable dynamic DHCP
Use
dresses using DHCP server. It is also possible to specify these values:
Item
Description
IP Pool Start
Beginning of the range of IP addresses which will be assigned to DHCP clients
IP Pool End
End of the range of IP addresses which will be assigned to DHCP clients
Lease Time
Time in seconds for which the client may use the IP address
All changes in settings will apply after pressing the
Wieland Electric GmbH | BA001039 (Rev. A) | 08/2016
station (STA) mode can be connected
ets from the available access point (AP) and sends data from cable connection via
wifi network
nected with LAN network of the router.
LAN network of the router. In this case, the setting of most items in this table is
ignored. Instead, it takes setting of selected network interface (LAN).
leases item at the bottom of this form to enable dynamic allocation of IP ad-
Configuration of DHCP server
Enable WLAN
Apply
button.
Contents of Package
interface check box at
38
Advertisement
Table of Contents
