Table of Contents
Advertisement
4 Status
4.1
General Status
A summary of basic information about the router and its activities can be invoked by selecting the
eral
item. This page is also displayed when you login to the web interface. Information is divided into a
separate blocks according to the type of router activity or the properties area –
mary LAN, Secondary LAN, Peripherals Ports and System Information
RS232-RS485-ETH version, there will be displayed a tertiary
there will be a WiFi block displayed, too.
4.1.1
Mobile Connection
Item
SIM Card
Interface
Flags
IP Address
MTU
Rx Data
Rx Packets
Rx Errors
Rx Dropped
Rx Overruns
Tx Data
Tx Packets
Tx Errors
Tx Dropped
Tx Overruns
Uptime
4.1.2
Primary LAN, Secondary LAN, Tertiary LAN, WiFi
Items displayed in this part have the same meaning as items in the previous part. Moreover, the MAC
Address item shows the
ondary LAN – eth1, Tertiary LAN – eth2, WiFi – wlan0).
4.1 or 4.5). If the router is equipped with PoE PSE board, additional information can be found in the
mary LAN or Secondary LAN
Item
PoE PSE Status
PoE PSE Power
PoE PSE Voltage
PoE PSE Current
Wieland Electric GmbH | BA001039 (Rev. A) | 08/2016
Description
Identification of the SIM card
Defines the interface
Displays network interface flags
IP address of the interface
Maximum packet size that the equipment is able to transmit
Total number of received bytes
Received packets
Erroneous received packets
Dropped received packets
Lost received packets because of overload
Total number of sent bytes
Sent packets
Erroneous sent packets
Dropped sent packets
Lost sent packets because of overload
Indicates how long the connection to mob. network is established
MAC address
of the corresponding router's interface
section (see table below for description).
Description
• Disabled – PoE PSE is disabled in the
figuration form.
• Undervoltage – Undervoltage, i.e. a lower voltage than the nominal operat-
ing voltage.
• Overcurrent – Overcurrent, i.e. a higher current than the permissible posi-
tive difference of the nominal current.
• Idle – PoE PSE is enabled, but currently not used.
• Class 0 – Power level (classification unimplemented)
• Class 1 – Power level (very low power)
• Class 2 – Power level (low power)
• Class 3 – Power level (mid power)
• Class 4 – Power level (high power)
Power of PoE PSE [W]
Voltage of PoE PSE [V]
Current of PoE PSE [mA]
PoE PSE information
. If the router is a SWITCH or
LAN
block. If the router is WiFi equipped,
(Primary or Secondary)
Visible information depends on configuration (see
Primary LAN
Status
Gen-
Mobile Connection, Pri-
(Primary LAN – eth0, Sec-
Pri-
Secondary LAN
or
con-
10
Advertisement
Table of Contents
