Contents Of Package; Lan Configuration - Wieland wienet v3 User Manual

Contents of Package

5 Contents of Package
5.1

LAN Configuration

LAN
Select the menu item to enter the network configuration for the Ethernet ports.
tem is intended for the first ETH router's interface (ETH0),
Tertiary LAN
interface (ETH1).
if installed, it is the ETH2 interface.
Item
DHCP Client
IP address
Subnet Mask
Bridged
Media type
PoE PSE
Default Gateway
DNS server
Default Gateway
The and
Primary or Secondary LAN is selected by the Backup Routes system as a default route. (The backup
routes selection algorithm is described in section
DNS Server
are also supported on bridged interfaces (e.g. eth0 + eth1).
There can be only one active bridge on the router at a time. Only the parameters
Subnet Mask
and can be used to configure the bridge. The Primary LAN has the higher priority when
both interfaces (eth0, eth1) are added to the bridge. Other interfaces (wlan0 – wifi) can be added (or de-
leted) to (from) an existing bridge at any time. Moreover, the bridge can be created on demand for such
interfaces but not configured by their respective parameters.
The DHCP server assigns the IP address, default gateway IP address, and IP address of the DNS server to
the connected DHCP clients. If these values are filled-in by the user in the configuration form, they are
preferred.
21
is for the SWITCH (3x Ethernet) or RS232- RS485-ETH expansion port
Description
• disabled – The router does not allow automatic allocation IP address
from a DHCP server in LAN network.
• enabled – The router allows automatic allocation IP address from a
DHCP server in LAN network.
Fixed set IP address of network interface ETH.
IP address of Subnet Mask.
• no – router is not used as a bridge (default)
• yes – router is used as a bridge
• Auto-negation – The router automatically sets the best speed and
duplex mode of communication according to the network's possibil-
ities.
• 100 Mbps Full Duplex – The router communicates at 100 Mbps, in
the full duplex mode.
• 100 Mbps Half Duplex – The router communicates at 100 Mbps, in
the half duplex mode.
• 10 Mbps Full Duplex – The router communicates at 10 Mbps, in
the full duplex mode.
• 10 Mbps Half Duplex – The router communicates at 10 Mbps, in
the half duplex mode.
• enabled – The router provides power on the Ethernet cable
• disabled – The router does not provide power on the Ethernet cable
(default)
IP address of router default gateway. If filled in, all packets not fitting
the route table rules would have been sent to this adress.
IP address of DNS server of the router. All the DNS queries are for-
warded to this address.
Configuration of the Network Interface
DNS Server
items are only used if the
Secondary
DHCP Client
Backup Routes
). Since FW 5.3.0,
Wieland Electric GmbH | BA001039 (Rev. A) | 08/2016
Primary
is for the second ETH router's
item is disabled, and if the
Default Gateway
DHCP Client, IP address
subi-
and