Table of Contents
Advertisement
Configuration in Typ. Situations
LAN
LAN
Primary LAN
configuration In the
item –
– you can leave the factory default configuration as in
the previous situation. The ETH1 interface on the front panel of the router is used for connection to the
Internet. It can be configured in Secondary
LAN
. Connect the cable to the router and set appropriate val-
ues as in the fig. 85 – here static IP address, default gateway and DNS server are configured. Changes
Apply
LAN
will take effect clicking on the
button. Detailed configuration of
is described in the 4.1 chap-
ter.
WLAN
WiFi
WLAN
and
configuration It's necessary to enable wlan0 network interface in the
item, see
Enable WLAN
Operating Mode to station (STA),
fig. 86. Check the
interface, set the
enable the DHCP cli-
ent and fill in the default gateway and DNS server for accessing the Internet. Click the Apply button to
confirm the changes. For details see chapter 4.6.
Enable WiFi
Configure connection to a WiFi network in the WiFi item, see fig. 87. Here check the
and fill
SSID
Apply
in the data for connection (
, security, password) and confirm clicking the
button. For detailed
configuration see 4.5 chapter.
WiFi
To verify successful WiFi connection, see Status section,
item.
There will be wpa_state=COMPLETED written out if connected successfully.
WLAN
Backed up access to the Internet –
configuration
Mobile
WAN
configuration To configure the mobile connection it is sufficient to insert the SIM card into
the SIM1 slot and attach the antenna to the ANT connector as in previous situation (depending on used
Mo-
SIM card). For using the system of backup routes it's necessary to enable check of connection in the
bile WAN
Check connection option to enabled + bind
item, see fig.. Set the
and fill in an IP adress of e.g.
operator's DNS server or any other surely available server and time interval of the check. For detailed
configuration see chapter 4.3.1.
Wieland Electric GmbH | BA001039 (Rev. A) | 08/2016
90
Advertisement
Table of Contents
