Table of Contents
Advertisement
4.5
Network Status
To view system information about the router operation, select the
upper part of the window displays detailed information about active interfaces:
Item
eth0, eth1, eth2
usb0
wlan0
ppp0
tun0
ipsec0
gre1
lo
Each of the interfaces shows the following information:
Item
HWaddr
inet
P-t-P
Bcast
Mask
MTU
Metric
RX
TX
collisions
txqueuelen
RX bytes
TX bytes
It is possible to read status of connection to mobile network from the network information.
If the connection to the mobile network is active, it will be shown in the system information as an usb0
interface. At the bottom, there is the Route Table displayed.
Wieland Electric GmbH | BA001039 (Rev. A) | 08/2016
Description
Network interfaces (ethernet connection)
Active PPP connection to the mobile network – wireless module is
connected via USB interface
WiFi interface
PPP interface (e.g. PPPoE tunnel)
OpenVPN tunnel interface
IPSec tunnel interface
GRE tunnel interface
Local loopback interface
Description of the interface in network status
Description
Hardware (unique) address of networks interface
IP address of interface
IP address second ends connection
Broadcast address
Mask of network
Maximum packet size that the equipment is able to transmit
Number of routers, over which packet must go trought
• packets – received packets
• errors – number of errors
• dropped – dropped packets
• overruns – incoming packets lost because of overload
• frame – wrong incoming packets because of incorrect packet size
• packets – transmit packets
• errors – number of errors
• dropped – dropped packets
• overruns – outgoing packets lost because of overload
• carrier – wrong outgoing packets with errors resulting from the
physical layer
Number of collisions on physical layer
Length of front network device
Total number of received bytes
Total number of transmitted bytes
Description of Information in Network Status
Network
Status
item in the
Status
menu. The
16
Advertisement
Table of Contents
