Miele HG05 Operating Instructions Manual page 92

Water connection
– The inlet hose is approx. 1.5 m long.
– A tap with a 3/4" male thread must
be provided on site.
– IMPORTANT: Australia and New
Zealand
This appliance must be installed
according to AS/NZS 3500.1. Back
flow prevention is already integrated
in the appliance.
– The water pressure (flow pressure at
the take-off point) must be between
50 and 1000 kPa (0.5 and 10 bar). If
the water pressure is lower than this,
the fault message
appear in the display (see "Problem
solving guide"). If the water pressure
is too high, a pressure reducer valve
must be fitted.
92
will
Water intake
After connecting the dishwasher to
the water supply, check that all
plumbing connections are watertight.

To avoid any damage to the
appliance, the dishwasher must only
be operated when it is connected to
a fully vented plumbing system.

The inlet hose must not be
shortened or damaged in any way as
it contains electrical components
(see illustration).