Miele HG05 Operating Instructions Manual page 12

Warning and Safety instructions

To avoid the risk of damage to the dishwasher, make sure that the
connection data on the data plate (fuse rating, voltage and
frequency) matches the mains electricity supply before connecting
the dishwasher to the mains. Consult a qualified electrician if in any
doubt.

Do not connect the dishwasher to the mains supply until it has
been fully installed and any adjustment has been made to the door
springs.

Do not connect the appliance to the mains electricity supply by a
multi-socket adapter or an extension lead. These do not guarantee
the required safety of the appliance (e.g. danger of overheating).

The dishwasher may only be operated if the door opening
mechanism is working correctly. Otherwise there could be a risk of
injury whilst the automatic door opening mechanism (depending on
model) is active.
To check that the door opening mechanism is working correctly:
– the door springs must be adjusted equally on both sides. They
are correctly adjusted when the door remains stationary when left
half open (approx. 45° opening angle). It is also important that the
door cannot fall open.
– the door locking pins automatically retract when the door opens
at the end of the drying phase.

This appliance must not be installed and operated in mobile
installations (e.g. on a ship).

Do not install the dishwasher in a room where there is a risk of
frost. Frozen hoses may burst or split. The reliability of the electronic
control unit may be impaired at temperatures below freezing point.

To avoid any damage to the appliance, the dishwasher must only
be operated when it is connected to a fully vented plumbing system.

The plastic housing of the water connection contains an electrical
valve. The housing must not be dipped in water.
12