Miele HG05 Operating Instructions Manual page 13


There are electrical wires in the water inlet hose. Do not cut the
water inlet hose, even if it is too long.

The integrated Waterproof system offers protection from water
damage, provided the following conditions are met:
– The dishwasher is correctly installed and plumbed in.
– The dishwasher is properly maintained and parts are replaced
where it can be seen that this is necessary.
– The tap has been turned off when the appliance is not used for a
longer period of time (e.g. during holidays).
The Waterproof system will work even if the appliance is switched
off. However, the appliance must remain connected to the electricity
supply.

The water pressure (flow pressure at the connection point) must
be between 50 and 1000 kPa (0.5 and 10 bar).

A damaged appliance could be dangerous. If the dishwasher gets
damaged, switch it off at the mains and call Miele.

The manufacturer's warranty will be invalidated if the appliance is
not repaired by a Miele approved service technician.

Faulty components must only be replaced by genuine Miele spare
parts. The manufacturer can only guarantee the safety of the
appliance when Miele replacement parts are used.

During installation, maintenance and repair work, the appliance
must be disconnected from the mains electricity supply.

If the mains connection cable is damaged, it must be replaced
with a special cable of the same type (available from Miele) by a
Miele authorised service technician only in order to avoid a hazard.
Warning and Safety instructions
13