Transporting The Sampler With A Sample Cooler Installed - Agilent Technologies 1260 Infinity II User Manual

3
Using the Module

Transporting the Sampler with a Sample Cooler Installed

Transporting the Sampler with a Sample Cooler Installed

When moving the sampler around the laboratory, make sure that any condensed water
N O T E
inside the thermostat is removed.
• Remove the drainage and place a beaker underneath the drain outlet of the sample
• Otherwise no special precautions are needed for the modules.
Heavy weight
WA R N I N G
The module is heavy.
➔
➔
➔
➔
Transporting the sampler with a sample cooler installed is only allowed for short
N O T E
distances. For longer distances, you must separate the units and send them independently.
52
cooler. Then carefully tilt the module to the back so that the water inside the
thermostat can safely flow into the leak funnel. If condensate removal is done
improperly, you can harm the electronic of the module.
Carry the module at least with 2 people.
Avoid back strain or injury by following all precautions for lifting heavy objects.
Ensure that the load is as close to your body as possible.
Ensure that you can cope with the weight of your load.
Agilent 1260 Infinity II Preparative Autosampler User Manual