TP-Link Archer MR200 User Manual page 64

Chapter 11
Downloaded from www.Manualslib.com
4. Click
Add
according to the following explanations:
• Destination IP:
assign to a static route. This IP address cannot be on the same
subnet with the WAN IP or LAN IP of the router. In the example,
the IP address of the company network is the destination IP
address, so here enters 172.30.30.1.
• Subnet Mask:
destination IP address. If the destination is a single IP address,
enter 255.255.255.255; otherwise, enter the subnet mask of
the corresponding network IP. In the example, the destination
network is a single IP, so here enters 255.255.255.255.
• Gateway:
data packets will be sent. This IP address must be on the same
subnet with the router's IP which sends out the data. In the
example, the data packets will be sent to the LAN port of
manuals search engine
to add a new static routing entry. Finish the settings
The destination IP address that you want to
Determines the destination network with the
The IP address of the gateway device to which the
Specify Your Network Settings
60