Add A Headset - AT&T TL96457 User Manual

Bluetooth
Bluetooth setup

Add a headset

Before you begin, make sure that your Bluetooth enabled headset is not
connected to any other Bluetooth device. Refer to your headset user's manual
to learn how to search for or add new Bluetooth devices.
To pair and connect a headset:
MENU
1. Press
2. Press or
CID
SELECT.
3. Press SELECT
4. Press or
CID
SELECT. The screen displays Please wait... followed by
If headset is connected to cell, please disconnect it..
If there are already four paired devices on the
f
device list, the fourth device on the device list will be
automatically removed, regardless of whether the new
device pairing is successful or not.
If there is another headset already active, the screen
f
will show Only the BT headset in slot 2 can be ready
for connection and then Headset X is deactivated
(Headset X represents the device name of the active
Bluetooth headset).
5. Press NEXT. The screen displays Pls set headset to
discoverable mode.
6. Set your headset to discoverable mode (refer to the
user's manual of your headset), then press NEXT. The
screen displays Searching for Bluetooth headsets....
All devices that are connected to the telephone base
f
are temporarily disconnected.
7. When the screen displays the found devices, press
or
CID DIR
press SELECT.
Enter the PIN of your headset, if required. The PIN for
f
most Bluetooth devices is 0000 (refer to the user's
manual of your headset). Press
on the telephone base in idle mode.
to highlight Bluetooth, then press
DIR
to choose Add device.
to highlight Add headset, then press
DIR
to highlight your headset, if necessary, then
NEXT to continue.
25
Cal ler ID log
Intercom
Cal l block
Bluetooth
BACK SELECT
BLUETOOTH
Add device
Device list
Download dir
BACK SELECT
ADD DEVICE
Add cel lular
Add headset
BACK SELECT
Pls set headset
to discoverable
mode
BACK NEXT
Searching for
Bluetooth
headsets...
FOUND DEVICES
Headset Y
Headset Z
BACK SELECT